![]() ![]() If the actual air temperature is more than 2 degrees away from the air set-point temperature for more than 10 minutes, the Controller will automatically enable the Hydronic Fan Coil(s) (Stage II) to rapidly bring the air temperature to the set-point.ĭomestic Hot Water (DHW) generation is via a heat exchanger that allows for heat transfer from the System working fluid (a non-toxic, food grade propylene glycol solution) and potable water. The Controller will fire the boiler and use the Hydronic Radiant Floor (Stage I) to maintain both the 65 degree floor Minimum temperature and 70 degree Air temperature set-points without exceeding the floor Maximum temperature set-point of 90 degrees. The end-user will set a heating target indoor air temperature – let’s say 70F degrees. The Installer will set the floor minimum and maximum temperatures to be compatible with the flooring, let’s say 65F and 90F degrees, respectively. ![]() The System can provide between ~23,000-60,000BTUs for space and domestic water heating, more than double the typical “D2 Air Heater” (~7200 BTU) installed in Vans. Indoor, outdoor and embedded floor sensors allow full control of floor minimum and maximum temperatures as well as indoor air temperature set-points with outdoor air temperature feedback. Balance of System mechanicals have been carefully engineered or selected to minimize the electrical demand of the system – which as of this writing has been reduced to ~30-70 Watts of DC power (including the boiler itself). In all radiant floor installations, service, and repair work that we perform, we use only the highest quality products, and strictly follow all. Fuel consumption is 0.07 to 0.16 gallons per hour in heating conditions or ~1/2 gal in a 24 hour period (primarily dictated by how well you have insulated). We offer units that will heat both your Radiant (space heating) and domestic hot water. Our team at Save Home Heat Company has been on the front lines of hot water radiant floor home heating for more than 40 years, consistently serving homeowners in the Denver-Boulder metro area. The System utilizes time tested, industry proven commercial vehicle coolant heaters (boiler) which in turn use the vehicle’s primary fuel source (diesel or gasoline). The two systems are basically tied together. The System also provides tankless, on-demand generation of Domestic (potable) Hot Water (DHW) which is limited only by the size of your freshwater tank. Introduction The open system uses one heat source, your domestic water heater, to provide both floor heating and domestic hot water. You may set the indoor air temperature either when occupied, via 7-day schedule or remotely via WiFi. The user interface is a WiFi enabled touchscreen which extends control of the System to your Android or iOS device if desired. The System is managed by our in-house designed and programmed “Van Life Tech Integration Controller”. Our proprietary design provides ‘whole house heating’ through a fully integrated Two Stage Hydronic System (Stage I – Radiant floor, Stage II – Fan coil unit(s)). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |